Your One Stop NDT Equipment Supplier
GammaTec

Transducers & Wedges

Transducers & Wedges

Standard twin crystal transducers housed in a stainless steel case for extra durability.
Holds two crystals mounted at inward angles that provide improved near-surface resolution and superior signal-to-noise ratio. Designed for use with the extensive range of Phoenix manual and automated scanners.
Ideal for the general purpose testing of welds, plate, pipe tubing, castings and forgings.
Ideal for use with the WREN Scanner and DTOF and CDTOF transducers with a reduced land, enabling wedges to sit closer to the weld cap.
Suitable for use on corroded and pitted surfaces, thickness measurement, brazed joint testing and for lamination detecting. High gain and resolution are achieved with a very low cross-talk.
Offers superior performance with a larger bandwidth for greater signal-to-noise ratio. Available with a stainless steel case, modified internal design and rear entry connectors.
Twin crystal shear wave transducers hold two crystals mounted at inward angles that provide improved near-surface resolution and superior signal-to-noise ratio. Ideal for inspecting thin materials for small flaws, occurring directly under the surface.
General-purpose coupling for standard phased array probes on flat surfaces is solved by this Phased Array UT Wedge. This reliable wedge establishes the acoustic interface, allowing the phased array unit to accurately steer and focus the ultrasonic beam for efficient NDT. Supplier: Sonatest Ltd.
Manufactured in black plastic with irrigation and gimbal pin options. For use with DTOF and CDTOF transducers.
High-resolution detection of small flaws and accurate thickness measurement in challenging components is solved by this TSTARC 4MHz Twin Crystal UT Probe. This dual element probe uses a separated crystal design to improve signal-to-noise ratio and enhance near-surface resolution. Supplier: Sonatest Ltd.
Ideal for the general purpose testing of welds, plate, pipe tubing, castings and forgings.
Highly damped transducers in a threaded housing, for use with demountable wedges in piezo-composite materials.
Used for the inspection of coarse grained and attenuative materials such as stainless steel or duplex.
Ideal for use with the WREN Scanner and DTOF and CDTOF transducers with a reduced land, enabling wedges to sit closer to the weld cap.
End of Results
Gammatec Contact Block

Need Assistance or Looking for Something Else?

Our team of Non-Destructive Testing experts is ready to help you find the perfect equipment and solutions tailored to your specific industry requirements.